Test and diagnostic information—Model V03
Printing the printer demonstration
1. Power off the printer.
2. Load the printer with at least 22 in. (55.9 cm) of blank, fanfold forms in the same tractor and forms path the
customer is using.
3. Power on the printer.
4. Press the Stop key to make the printer Not Ready (only the Power LED and the OnLine key are lighted).
5. Press the Test key. The message 4247 OPERATOR Print TESTS appears.
6. Press the Micro
7. Press the Enter key, and wait for the test to finish.
8. Press the Cancel Print key to exit test mode.
Printing the firmware part number and version levels
1. Power off the printer.
2. Load the printer with at least 22 in. (55.9 cm) of blank, fanfold forms in the same tractor and forms path the
customer is using.
3. Power on the printer.
4. Press the Stop key to make the printer Not Ready (only the Power LED is lighted).
5. Press the Test key. The message 4247 OPERATOR Print TESTS appears.
6. Press the Micro
7. Press the Enter key, and wait for the firmware part number Controller, and Attachment Code versions to print.
key until the Printer Demonstration test is displayed below 4247 OPERATOR Print TESTS.
key until the Firmware Information test is displayed below 4247 OPERATOR Print TESTS.
97
Chapter 2. Diagnostics