Paper bail assembly
Plastic
Strip
Mylar
Paper Bail
Assembly
1. Turn off the printer and unplug the power cord from the
printer.
2. Open the top cover and remove the ribbon.
3. Move the printhead to the far right.
4. Note the position of the paper bail asm.
5. To remove the paper bail, grasp it as shown. Rotate the paper
bail toward the front of the printer until the pivot posts on the
sides can disengage.
Installation notes
1. Move the printhead to the far right.
Attention:
In the next step, ensure the plastic strip points down
to avoid damaging the strip.
2. Grasp the paper bail, as shown.
3. Insert the left and right paper bail end caps, and pivot the
paper bail down into the side frames.
4. Rotate the paper bail toward the back of the printer, closing it
as far as it will go.
5. Reinstall the ribbon cartridge.
Chapter 5. Removals, service checks and adjustments
225