Carriage Support Shaft - IBM V03 Maintenance Information

Carriage support shaft

Carriage Support
Shaft Bushing
Carriage Support
Shaft
Screw
Eccentric
Bushing
Perform the following procedures first:
1. Remove the Rear cover.
2. Remove the Top cover asm..
Then:
1. Mark the position of the eccentric adjustment bushing for
reference during installation.
2. Remove the left and right (carriage) support shaft screws.
3. Remove the old support shaft from the printer.
Installation notes
1. Install the carriage assembly support bushing on the new
shaft.
2. Install the eccentric bushing onto the flat end of the new shaft.
3. Install the new shaft into the printer, with the eccentric bushing
on the right side.
4. Position the eccentric bushing to the reference mark.
5. Install the support shaft into the right side of the frame using
the screw.
6. Install the support shaft into the left side of the frame using
the screw.
7. Perform the carriage support shaft adjustment (see Carriage
support shaft).
Chapter 5. Removals, service checks and adjustments
217