Carriage Drive Motor Assembly And Fan - IBM V03 Maintenance Information

Carriage drive motor assembly and fan

CAUTION:
<2-25> High temperature; switch off the printer and allow at least 20 minutes for parts in this area to cool before
handling.
Tractors
Operator Panel
Attachment
Connector
Printhead
Printhead
22 Pin
26 Pin
Connector
Printhead
Connector
12 Pin
Connector
Sensors
Logic Board
F2 (not a FRU)
Power Supply Connector
Board Fan
Carriage Fan
AFTA Motor
F1 (not a FRU)
Ribbon Drive Motor
Carriage Drive Motor
Paper Feed Motor
Power Supply
Perform the following procedures first:
1. Remove the Rear cover.
Power Switch
2. Remove the Top cover asm..
(not a FRU)
Then:
1. Open the top cover and remove the ribbon.
2. Disconnect the carriage motor fan connector from the power
supply board and remove the cable from the cable retainers
located in the rear part of the mechanical asm.
3. Disconnect the carriage motor connector from the logic board
and remove the cable from the cable retainers located in the
rear part of the mechanical asm.
Chapter 5. Removals, service checks and adjustments
214