IBM V03 Maintenance Information page 114

The printer displays:
T&D11 Tear-Off Line Adjustment Test TEAR REAR ADJ? YES NO
3. To adjust the tear-off line for the rear tractor feed, press the Line Feed key.
4. If the front tractor is installed and you want to advance to its tear-off line adjustment, press the Start key. The
procedure to adjust either front or rear tear-off line is the same.
5. If fanfold paper is not loaded, the display is:
T&D11 Tear-Off Line Adjustment Test LOAD PAPER
6. Install fanfold paper in the rear tractor assembly.
7. Press the Load/Eject key.
8. A line of Xs will be printed on the first print-line. The paper will feed to the tear-off bar for viewing. The Xs
should be completely on the paper. The top of the Xs should be approximately 1 mm (0.04 in.) below the
perforation. If this condition does not exist, perform T&D09—First printing line adjustment test, and then
return here.
9. The following message displays:
T&D11 Tear-Off Line Adjustment Test TEAR XXXX 0 + RUN -
10. Figure 4 shows the correct position of the perforation for a clean tear-off.
114
Chapter 2. Diagnostics