Printer Mechanical Assembly - IBM V03 Maintenance Information

Printer mechanical assembly

Stacker Operator Tractors
Panel
Coax/Twinax Print Carriage
Card Head Motor
Ground
Sensors
Paper
Feed
Motor
Ribbon
Motor
AFTA Carriage
Fan
Ground Ground
Perform the following procedures first:
1. Remove the Rear cover.
2. Remove the Top cover asm..
3. Remove the Front (optional, second) tractor.
4. Remove the Rear (base) tractor.
5. Remove the Attachment cards: serial, twinax, LAN, coax.
6. Remove the Logic board.
Then:
1. Disconnect the carriage motor fan connector from the power
supply.
2. Remove the 2 ground strip screws.
3. Remove the 2 mounting screws.
The right side screw can be accessed through the cable slot
in the fan mounting bracket, or by using an offset screwdriver.
4. Remove the 2 wire ties.
The printer mechanical assembly will not come straight up.
Pivot it to the front, disengaging the rubber grommets, and
then lift it out.
5. Remove the 4 screws holding the mechanical asm. on to the
base asm.
Installation notes
Attention: Do not pinch the cables during installation.
Chapter 5. Removals, service checks and adjustments
231