T&D13-Top Cover Interlock Test; T&D14-Nlq Printhead Mode - IBM V03 Maintenance Information

6. Tear off the printout, and press any key.
7. For printout analysis, see Print quality service checks.
8. If an error message is displayed, go to T&D error messages and actions.
9. The test completed successfully if the display advances to the next test number.
T&D13—Top cover interlock test
If the top cover is open when this test starts, the following messages will alternately display:
T&D13 Top Cover Interlock Test COVER IS OPEN
T&D13 Top Cover Interlock Test PLEASE CLOSE IT
1. Close the top cover, if open. The following message will display:
T&D13 Top Cover Interlock Test RUN TEST ? YES END NO
2. Press the Line Feed key. The following message will display:
T&D13 Top Cover Interlock Test OPEN COVER
3. Open the top cover. If you do not open the cover in approximately 10 seconds, the following message will
display:
T&D13 Top Cover Interlock Test CLOSE COVER
4. Close the cover.
Note: If the cover is not closed in approximately 10 seconds, an error message will be displayed.
5. If an error message is displayed, go to T&D error messages and actions.
6. The test completed successfully if the display advances to the next test number.
T&D14—NLQ printhead mode
Use this test to select how the printhead prints in Near Letter Quality (NLQ) mode. The default setting is NLQ 18
WIRE.
117
Chapter 2. Diagnostics