IBM V03 Maintenance Information page 196

5. Attention: Ensure that the attention light wire is routed up
through the operator panel hole and out of the top cover (tape
it to the outside of the top cover).
6. Standing in front of the printer, grasp 1 side-cover hand-hold
and spread the top cover, pulling it up and over the edge of
the base.
7. Grasp the other side-cover hand-hold and do the same.
The top cover is now sitting on the top of the base.
8. Grasp both hand holds and carefully lift forward and up to
remove the top cover.
Installation notes:
Perform the tear-off line adjustment. See Tear-off line.
Chapter 5. Removals, service checks and adjustments
196