Insertion And Removal Of Omnii - Motorola 7545MBW User Manual

IMPORTANT
MT3325 Standard Arm Kit with Omnii Vehicle Cradle Clamp and Rail Bases (Torque to 26 in-lbs)
Figure 4-18
To accommodate the service loop of the connector cable, leave a 4" clearance at the bottom of the cradle.
Leave a 7" (minimum) clearance at the top of the cradle to allow easy removal of the hand-held. Refer to the
detailed assembly instructions that are packaged with the cradle when selecting a mounting location (Omnii
Vehicle Cradles Quick Start Guide PN 8000221).

Insertion and Removal of Omnii

If your Omnii is equipped with a cover, or the ST6025 Double Loop Hand strap, these accessories need to be
removed before installing the unit in a vehicle cradle. There is no need to remove other hand straps or pistol
grips from the unit.
• Slide the Omnii into the cradle, and press firmly downward until it locks into place. On a vehicle, it's a good
idea to pull up on the Omnii to be certain that it is secure.
• To remove the Omnii, press the release button on the front of the cradle until it releases.
Plate bases are not recommended for forklift mounting solutions. If a plate
rather than a clamp base is used, you will need to penetrate into the struc-
ture of the vehicle, a process requiring additional hardware. The following
plate bases are available:
• VESA Plate – MT3501
• Circular Plate – MT3502
MT3325 Arm
MT3326 Bracket
Accessories 4 - 21
Omnii
ST1002 Cradle
(powered)