Maintaining The Vehicle Cradle; St1002 Powered Cradle Installation - Motorola 7545MBW User Manual

4 - 22 Omnii Hand-Held with Windows CE 6.0 User Manual
Inserting Omnii into the vehicle cradle
Figure 4-19

Maintaining the Vehicle Cradle

Two latches in the cradle hold the Omnii firmly in place. Although these latches are designed for at least
100,000 insertion and removal cycles, they will wear over time and will no longer lock the Omnii securely in the
cradle. For replacement parts and instructions contact Motorola. Partial disassembly is required.

ST1002 Powered Cradle Installation

The ST1002 cradle is designed to allow the Omnii to be powered by a vehicle battery. The battery installed in
the Omnii is also recharged by the vehicle battery. This option accepts DC power sources over the range 11.5V
to 30V. Voltages above that require the use of the preregulator (Model No. PS1350).
WARNING
The ST1002 Vehicle Cradle has a 44-pin connector that allows connection with either the CA3001 Vehicle
Cradle Power and Communications Cable (DE9M serial port, 2 USB Host interfaces, and power cable) or the
power-only CA3000 Vehicle Cradle Power Cable. For connector pinouts and a cable connections diagram, see
"Cable Connectors for Vehicle Cradle Model ST1002" on page
Release button
Applying a voltage greater than that specified, or reversing polarity, may
result in permanent damage to the cradle power option and will void the
product warranty.
Operating an Omnii XT15f Arctic unit in operating temperatures from -30°C
to +50°C, requires the use of the power preregulator Model No. PS1370.
A-5.