Heater System; Display And Scan Window Heaters - Motorola 7545MBW User Manual

F - 10 Omnii Hand-Held with Windows CE 6.0 User Manual

Heater System

This section displays information on the heater system.
Status
The LED state for this parameter indicates whether the communication with the Quick Defrost hardware is
successful (green) or unsuccessful (red).
Voltage
This indicates the voltage applied to the heater system.
Current
This shows the total average current used by the heating system.
Power
This represents the total power used by the heating system.
Temperature
This shows the temperature measured inside the unit.
Humidity
This shows the humidity measured inside the unit.

Display and Scan Window Heaters

This section displays information on the individual heaters.
NOTE
If the scanner/imager is not connected, the scan window heater will be disabled
(greyed out).
Status
These status indicators report the heating mode for each individual heater.
Status LED
Current
This indicates the average current drawn at the moment for the individual heater.
Power
This indicates the power used at the moment for each individual heater.
Temperature
Shows the temperature measured near the heating element.
Heating Element Status
Blue indicates the heating element is operating in full power mode.
Green indicates the heating element is operating in sustaining mode.
Grey indicates the heating element is off.
Red indicates a hardware failure with the heater.