4 - 8 Omnii Hand-Held with Windows CE 6.0 User Manual
Snap Module Ports
Figure 4-5
ST4000 (Charger)
No ports
Snap Module Installation
Figure 4-6
To attach the Snap Module charger to the Omnii:
•
Make sure that the charger connector and the Omnii docking connector are free of dust or any other debris
before connecting them.
•
A slot in the side rail on each side of the hand-held accommodates the locking clips of the charger. To
attach the charger, align it with the base of the hand-held and gently slide up until the locking clips snap
into place (Refer to
•
To remove the charger, press down on the base of the clip arms to release them from the Omnii side rails
and slide the adaptor off.
ST4001 (USB)
Micro-B port
Back of Snap Modules
Hand strap slot
Figure 4-6 Snap Module Installation on page
Type A (Host) USB port
(5 VDC, 500 mA max)
DC IN port (12V, 2.5 A)
Side rail
Locking clip
4-8).
ST4005 (Serial)
Powered DE9M Serial port
(9 pin, 5VDC, 1A max)
DC IN port