Charging A Battery Installed In The Omnii; Indicators; Operation; Charging The Omnii Battery - Motorola 7545MBW User Manual

Charging a Battery Installed in the Omnii

• Insert the DC power cable to the DC IN port on the desktop docking station. Plug the pronged end of the
cable into an AC outlet.
• Slide the hand-held into the docking station, making certain that the hand-held is securely seated on the
docking station connector pins and engages the locking arms of the docking station. When the Omnii is
switched on, a message is displayed briefly on the screen indicating that the unit is properly installed in the
station and the docking station icon is displayed in the taskbar.
The LED on the Omnii lights up indicating that the unit has external power and battery charging will begin. It is
safe to leave the unit in the desktop docking station while it is not in use — the battery will not be overcharged.

Indicators

The front-mounted LED on the desktop docking station indicates the spare battery charge status. The LED on
the Omnii is active even when the hand-held is inserted in a docking station (and in suspend mode) so that the
charge status of the battery can be detected easily.
Charge LED Behaviour
OFF
Solid Green
Flashing Green
Flashing Yellow
Solid Red

Operation

Charging the Omnii Battery

The desktop docking station supplies DC power to enable the Omnii internal fast charger.
When installed in the dock, the Omnii battery charge LED will illuminate to indicate the unit has external power
and can charge the internal battery. The Omnii charge indication follows the same convention as the charger's
spare battery indicator
NOTE
Battery charging continues whether the Omnii is switched on or off.

Charging the Spare Battery

IMPORTANT
• Install the battery in the battery charging bay (rear slot of the desktop docking station). Place the battery
contacts down to mate with the connector, and pivot the battery into place in the battery charging bay.
• The desktop docking station spare battery LED lights up immediately. During charge the LED will be
flashing green.
• When the battery has finished charging, the LED turns solid green.
• The charge stops when the battery is fully charged and the LED remains green.
No battery detected.
Battery charging complete.
Charge in progress.
Battery is not charging due to out-of-temperature conditions.
A charging timeout, unable to read battery, or non Motorola
battery.
(Figure 4-9 Desktop Docking Station - Models ST4002 and ST4003 on page
Do not store spare batteries in a charger for more than 72 hours. Doing so
may damage the battery or reduce its charge capacity.
Accessories 4 - 13
Function
4-12).