Driver Mode Configuration; Modem Information - Motorola 7545MBW User Manual

G - 12 Omnii Hand-Held with Windows CE 6.0 User Manual

Driver Mode Configuration

By default, the Wireless WAN driver is enabled (the Enable driver check box is checked). If the Enable driver
check box is not checked, the driver is shut down as soon as the OK button in the Driver Mode dialog box
is chosen.
If, on the other hand, the Wireless WAN driver is not running and the Enable driver check box is checked, the
Wireless WAN driver is started as soon the Driver Mode dialog box is closed using the OK button.
NOTE
When the driver is not running, no network status or signal strength can
be displayed.
Since all currently supported GSM modems are automatically detected, the Enable automatic port detection
check box should always be checked. If this check box is not checked, a serial port can be selected manually.
This experimental feature allows the driver to be used with an internal GSM modem that was not recognized by
the automatic detection or an external GSM modem connected to a serial port of the computer through USB or
through Bluetooth. An external modem connected to a serial port must support 115.2 kbit/s, 8bit, no parity and
hardware flow control.

Modem Information

The fields in this dialog box cannot be edited, they only display information about the computer's modem. If the
network operator has not programmed a user's phone number into his SIM, the Phone: field remains empty. If
the main menu shows an error status, at least partial modem information may be available.