Switching The Omnii On And Off - Motorola 7545MBW User Manual

Removing the Battery Pack
• If your unit is equipped with a hand strap, unhook it from the base of the battery.
• Press the two buttons at the sides of the compartment simultaneously, and slide the battery out.
Installing the Battery Pack
• Slide the charged battery with the contoured plastic facing you into the unit with the contacts matching
position and the guide tabs moving into the corresponding slots at the base of the compartment. Click both
sides of the battery into place.
• If your computer is equipped with a hand strap, re-attach the clip to the slot at the base of the battery.
• Switch the unit on (see

Switching the Omnii On and Off

Follow the instructions below for your Omnii. If your keyboard has a power button (55- and 66-key keyboards
only), press that instead of the [FN]+[Enter/Power] key combinations described.
Switching the Omnii On
• Press and hold down the [Enter/Power] key for at least one second.
When the unit is turned off, normally it automatically enters a power-saving, "suspend" state. When the Omnii
is switched on from the suspend state, within a few seconds operation resumes in the screen in which you
were working prior to turning the computer off.
IMPORTANT
Switching the Omnii Off
• To switch off the Omnii, press the [FN] key and then press and release the [Enter/Power] button. The
Omnii will automatically enter the Suspend state.
IMPORTANT
"Switching the Omnii On and Off" on page
If your Omnii fails to power up, consider the following troubleshooting options:
The battery may be overheated (>60C°), a non-Motorola battery may be
installed, or the battery may have fallen below the configured Suspend Thresh-
old. See "Suspend Threshold and Estimated Battery Backup" on page 3-45
for details.
To switch on the hand-held, you will need to replace the overheated battery.
However, if you supply AC power to the Omnii with a battery that falls
below the configured Suspend Threshold, the unit will switch on.
Turning off the hand-held does not result in a complete shutdown;
rather, the unit enters a power-saving, "suspend" state. When the
Omnii is turned on from suspend state, operation resumes within a
few seconds.
Basic Operation 1 - 7
1-7).