Resetting The Omnii; Performing A Warm Reset; Performing A Cold Reset - Motorola 7545MBW User Manual

1 - 8 Omnii Hand-Held Computer with Windows CE 6.0 User Manual
IMPORTANT

Resetting the Omnii

To perform a warm or cold reset, you can access the menu by going to Start>Shutdown. Alternatively you can
use the keyboard shortcuts described below.
NOTE
If your Desktop is switched to the Kiosk Shell (refer to
on page

Performing a Warm Reset

During a warm reset, running programs are halted. The contents of the file system, RAM Disk, Flash Disk, and
the registry are preserved.
• Press and hold down the [FN] key and the [Enter/Power] key simultaneously for a minimum of
four seconds.
NOTE
You need to reset your Omnii after configuring the radio by switching between
Windows Zero Config and WiFi Config.

Performing a Cold Reset

A cold reset reinitializes all hardware. All RAM including the RAM Disk is erased. Non-volatile storage such as
the Flash Disk is preserved, as is the file system.
To execute a cold reset:
• Press and hold down the [SYM] key, the [FN] key, and the [Enter/Power] key, simultaneously for a
minimum of four seconds.
If the word 'FN' is displayed underlined in the taskbar area at the
bottom of the screen, this key is locked "on" and the Omnii will not
switch off. Press the [FN] key twice followed by [Enter/Power] to
switch the Omnii off.
However, if you've set the mode to "Lock" (see
Modes" on page 3-34), the Omnii can be turned off even when the
[FN] key is locked 'on'.
2-27), resetting the unit is done solely by use of the keyboard shortcuts.
"Keyboard One Shot
"The Kiosk Desktop Shell"