Omnii Xt15Ni (Non-Incendive) Important Safety & Regulatory Information - Motorola 7545MBW User Manual

Omnii XT15ni (non-incendive) Important Safety & Regulatory Information
The Omnii XT15ni (non-incendive) Hand-Held Computer has been qualified by UL LLC to the requirements of
the USA and Canada for use in Class I, Division 2-Groups A, B, C and D T6 environments.
The users of this product are cautioned to use accessories and peripherals approved by Motorola. The use of
accessories other than those recommended, or changes to this product that are not approved by Motorola,
may void the compliance of this product and may result in the loss of the user's authority to operate the equip-
ment.
WARNING
This mark indicates that the user should read all included documentation
before use.
WARNING
Ce marquage indique que l'usager doit, avant l'utilisation, lire toute la doc-
umentation incluse.
WARNING
Explosion Hazard-Substitution of components may impair suitability for
Class I, Division 2 locations.
WARNING
This unit has NO OPERATOR REPLACEABLE PARTS other than the battery
pack. Disassembly/assembly of the Omnii XT15ni must be performed by
trained Motorola service personnel at a Motorola service depot. No unau-
thorized substitution of parts is allowed for the Omnii XT15ni hand-held.
Use ONLY the Motorola Model ST3001-NI battery pack in the Omnii XT15ni. No substitutions
are permitted without authorization from Motorola personnel.
DO NOT CHARGE OR CHANGE BATTERIES in an area that is known to be hazardous.
Replace batteries in an area known to be non-hazardous.
EXPLOSION HAZARD. DO NOT REMOVE OR REPLACE LAMPS, FUSES OR PLUG-IN
MODULES (AS APPLICABLE) UNLESS POWER HAS BEEN DISCONNECTED OR THE
AREA IS KNOWN TO BE FREE OF IGNITIBLE CONCENTRATIONS OF FLAMMABLE
GASES OR VAPORS.
EXPLOSION HAZARD. DO NOT DISCONNECT WHILE THE CIRCUIT IS LIVE UNLESS THE
AREA IS KNOWN TO BE FREE OF IGNITIBLE CONCENTRATIONS.
WARNING
Exposure to some chemicals may degrade the sealing properties of mate-
rials used in the following devices: battery packs, housings, LCDs,
touchscreens, keypads.
Replacement of modules, housings, keypads, LCDs or touchscreens,
end-caps, pods or external connectors must only be performed at an
authorized Motorola service centre.
Omnii XT15ni Non-Incendive Safety Guidelines I - 3