Motorola 7545MBW User Manual page 220

C - 6 Omnii Hand-Held with Windows CE 6.0 User Manual
Power Mode
This parameter is a power-saving option. Tapping on it displays a screen listing two power mode options:
Continuous Power and Low Power.
In Continuous Power mode, the scanner is always on, waiting for a trigger pull or serial communication.
In Low Power mode, the scanner is in a suspend state, drawing minimal power until a trigger pull or serial
communication wakes it. Keep in mind that while this option is more suitable for battery powered applications,
there will be a slight delay while the scanner powers up to scan a barcode.
Low Power Timeout
To extend laser life, you can select the time the scanner remains active following a successful decode. The
scanner wakes from low power mode when a barcode is scanned — a successful decode restores normal
flashing.
This is only used if the unit's Trigger Mode has been changed to Continuous On. If the unit is used in a fixed
mount this parameter might be used, but not if the unit is used as a hand-held.
When you double-tap on this parameter, a dialog box is displayed in which you can choose a value of 30 sec.,
1 min., 2 min. or 3 min.
NOTE
This parameter is only used if the Trigger Mode has been set to Continuous On
and the Omnii is mounted in a fixed position; otherwise, Low Power Timeout is
not used.
Parameter Scanning
Setting this parameter to on enables decoding of parameter barcodes.
Linear Security Level
This parameter allows you to select the security level appropriate for your barcode quality. There are four levels
of decode security for linear code types (e.g., Code 39, Interleaved 2 of 5). Higher security levels should be
selected for decreasing levels of barcode quality. As security levels increase, the scanner decode speed
decreases.
Double-tapping on this parameter displays a dialog box in which you can enter a value from 1 to 4.
Linear security level 1 specifies that the following code types must be successfully read twice before
being decoded:
Code Type
Codabar
MSI Plessey
D 5 of 5
I 2 of 5
Linear security level 2 specifies that all types of codes must be successfully read twice before being decoded.
Linear security level 3 specifies that code types other than the following must be successfully read twice before
being decoded. The following codes must be read three times:
Length
All
4 or less
8 or less
8 or less