Table of Contents
Advertisement
6.3.2. PPPoE (Point-to-Point Protocol over Ethernet)
This menu provides options for configuring PPPoE connection. You can use a PPPoE
connection to access the camera over the Internet when your ISP provides a dynamic IP address
and a username and a password for PPPoE authentication.
To enable PPPoE, select the option for [On]. After that, the PPPoE parameters will appear
(Pic. 6.23).
IP address: enter a PPPoE IP address (obtained from the server).
User ID: enter a PPPoE username. The maximum length is 64 characters (assigned by
your ISP or PPPoE provider).
Password: enter the PPPoE password. The maximum length is 32 (assigned by your ISP
or PPPoE provider).
Re-type password: re-type the entered password to ensure that there are no typing
mistakes.
Obtain DNS server address automatically: select this option to obtain a DNS address
automatically.
Use the following DNS server address: a DNS server address is manually specified.
Primary DNS server: enter the IP address of the primary DNS server.
Secondary DNS server: enter the IP address of the secondary DNS server.
IMPORTANT:
You must reboot the camera for the changes to take effect. To do so, go to SETTING – Basic – System –
Initialize.
N35110 Operations User Manual
Chapter 6. SETTING: Basic Menu
Pic. 6.23
45
Advertisement
Table of Contents
