Pppoe - Beward N37210 Owner's Manual

NOTE:
The [Obtain DNS server address automatically] option is available only when the [Obtain an IP address
automatically (DHCP)] option is selected.
Use the following IP address: select this option to type the IP address manually. The
following items are available:
 IP address: type the IP address. The default IP address is 192.168.0.99.
 Subnet mask: type the subnet mask. The default value is 255.255.255.0.
 Default Gateway: type the gateway IP address. The default value is 192.168.0.1.
Use the following DNS server address: select this option to type DNS servers' addresses
manually. This option is available when the option for static IP address is used as well as when it is
obtained automatically from a DHCP server.
 Preffered DNS server: type the preffered DNS server IP address.
 Alternate DNS server: type the alternate DNS server IP address.
HTTP Port: the default value is 80. You can set the value of the port between the values of
1124 and 65534.
NOTE:
If you use the HTTP port number other than 80, you need to type both your camera IP address and HTTP
port number. For example, if your camera's address is 192.168.1.100 and its HTTP port is 8081, you need
http://192.168.1.100:8081
to type

8.1.2. PPPoE

This section allows you to configure the PPPoE connection. It can be used to connect the
camera to the Internet when the Internet service provider assigns it a dynamic IP address and user
name and password PPPoE authentication is used.
To enable PPPoE feature, switch the option to [On]. It also will make PPPoE options
available (Pic. 8.2).
N37210 Operations User Manual
in your browser's address bar to access the camera.
Chapter 8. The [SETTING] Menu: Network
36