Pppoe (Point-To-Point Protocol Over Ethernet) - Beward N1250 Operatotion User Manual

 Primary DNS server: type the primary DNS server IP address.
 Secondary DNS server: type the secondary DNS server IP address.
HTTP port number: the default value is 80. You can set the value of the port between the
values of 1124 and 65535.
NOTE:
If you use the HTTP port number other than 80, you need to type both your camera IP address and HTTP
port number. For example, if your camera's address is 192.168.1.100 and its HTTP port is 8081, you need
to type http://192.168.1.100:8081
IMPORTANT:
You must restart the camera for the changes to take effect. To do so, go to SETTING – Basic – System –
Initialize.

6.3.2. PPPoE (Point-to-Point Protocol over Ethernet)

This section allows you to configure the PPPoE connection. It can be used to connect the
camera to the Internet when the Internet service provider assigns it a dynamic IP address and
username and password PPPoE authentication is used.
To enable PPPoE feature, select the option for [On]. It also will make PPPoE options
available (Pic. 6.22).
N1250 Operations User Manual
in your browser's address bar to access the camera.
Pic. 6.22
Chapter 6. SETTING: Basic
44