Pppoe (Point-To-Point Protocol Over Ethernet) - Beward N 13102 Operation User's Manual

server address automatically] option is available, which allows a DNS address to be
automatically obtained.
NOTE:
The [Obtain DNS server address automatically] option is available only when the [Obtain an IP address
automatically (DHCP)] option is selected.
Use the following IP address: select this option to type the IP address manually. The
following items are available:
 IP address: type the IP address. The default IP address is 192.168.0.99.
 Subnet mask: type the subnet mask. The default value is 255.255.255.0.
 Default gateway: type the gateway IP address. The default value is 192.168.0.1.
Use the following DNS server address: select this option to type DNS servers' addresses
manually. This option is available when the option for static IP address is used as well as when it is
obtained automatically from a DHCP server.
 Primary DNS server: type the primary DNS server IP address.
 Secondary DNS server: type the secondary DNS server IP address.
HTTP port number: the default value is 80. You can set the value of the port between the
values of 1124 and 65535.
NOTE:
If you use the HTTP port number other than 80, you need to type both your camera IP address and HTTP
port number. For example, if your camera's address is 192.168.1.100 and its HTTP port is 8081, you need
to type http://192.168.1.100:8081
IMPORTANT:
You must restart the camera for the changes to take effect. To do so, go to SETTING – System –
Initialize.

8.2. PPPoE (Point-to-Point Protocol over Ethernet)

This section allows you to configure the PPPoE connection. It can be used to connect the
camera to the Internet when the Internet service provider assigns it a dynamic IP address and
username and password PPPoE authentication is used.
To enable PPPoE feature, select the option for [On]. It also will make PPPoE options
available (Pic. 8.3).
N13102 Operations User Manual
in your browser's address bar to access the camera.
Chapter 8. SETTING: Network
42