Chapter 4. Managing the IP Camera via Internet Explorer
Step 1: connect your camera according to the User manual.
Step 2: open Internet Explorer, type the camera's IP address in the address bar. The
default IP address is 192.168.0.99.
NOTE:
There are two ways to assign an IP address to this IP camera:
1. An IP address can be obtained automatically from a Dynamic Host Configuration Protocol (DHCP)
according to the network parameters.
2. Use a manually specified IP address. See
administrator to avoid IP address conflict.
NOTE:
To view the camera images without showing the control panel, type «http://<IP>/index2.htm» in the
address bar of the browser. <IP> is the IP address of your camera
Step 3: enter the camera's
username and password in the
authorization window (Pic. 4.1).
The default user name is
«
»
admin
, the default password is
«
»
admin
.
IMPORTANT!
You can change the camera's user name and password at SETTING – Basic – Security – Account. If
you forgot your user name or password, you can reset your camera to factory settings by holding [RESET]
button during 10-15 seconds. Hold [RESET] button during 5-7 seconds to restart the camera.
By default, Windows prevents ActiveX add-ons from running but some ActiveX add-ons are
required to operate this IP camera. Therefore, you need to install the ActiveX add-ons to operate
your camera.
N35110 Operations User Manual
Chapter 4. Managing the IP Camera via Internet Explorer
paragraph 6.3.1
for details. Contact your system
Pic. 4.1
11