Pppoe (Point-To-Point Protocol Over Ethernet) - Beward N1000 Operation User's Manual

HTTP port number: the default value is 80. You can set the value of the port between the
values of 1124 and 65535.
NOTE:
If you use the HTTP port number other than 80, you need to type both your camera IP address and HTTP
port number. For example, if your camera's address is 192.168.1.100 and its HTTP port is 8081, you need
to type http://192.168.1.100:8081
IMPORTANT:
You must restart the camera for the changes to take effect. To do so, go to SETTING – Basic – System –
Initialize.

6.3.2. PPPoE (Point-to-Point Protocol over Ethernet)

This section allows you to configure the PPPoE connection. It can be used to connect the
camera to the Internet when the Internet service provider assigns it a dynamic IP address and
username and password PPPoE authentication is used.
To enable PPPoE feature, select the option for [On]. It also will make PPPoE options
available (Pic. 6.19).
IP address: IP address from PPPoE server (assigned by server).
User ID: type a username for PPPoE connection. The maximum length is 64 characters
(assigned by your Internet service provider or PPPoE provider).
Password: type a password for PPPoE connection. The maximum length is 32 (assigned
by your Internet service provider or PPPoE provider).
N1000 Operations User Manual
in your browser's address bar to access the camera.
Pic. 6.19
Chapter 6. SETTING: Basic
42