Chapter 4. Managing The Ip Camera Via Internet Explorer - Beward N300 Operation User's Manual

Chapter 4. Managing the IP Camera via Internet Explorer

Step 1: connect your camera according to the Installation User Manual.
Step 2: open Internet Explorer, type your camera's IP address in the address bar. The
default IP address is 192.168.0.99.
NOTE:
There are two ways to assign an IP address to an IP camera.
1. An IP address can be obtained automatically from a Dynamic Host Configuration Protocol (DHCP)
according to the network parameters.
2. Use a manually specified IP address. See paragraph
administrator to avoid IP address conflict.
Step 3: enter user name and password in the authorization window (Pic. 4.1).
The default username is
IMPORTANT:
You can change username and password at
username or password, you can reset your camera to factory settings by holding [RESET] button during
15 seconds.
By default, Windows prevents ActiveX add-ons from running which are required to operate
an IP camera. Therefore, you need to install the ActiveX add-on to operate your camera.
N300 Operations User Manual
Chapter 4. Managing the IP Camera via Internet Explorer
« »
admin , the default password is
Pic. 4.1
[SETTING] – System – Security. If you forgot your
8.1.1 for details. Contact your system
« »
admin .
10