Chapter 4. Managing The Ip Camera Via Internet Explorer - Beward N1250 Operatotion User Manual

Chapter 4. Managing the IP Camera via Internet Explorer

Step 1: connect your camera according to the User manual.
Step 2: open Internet Explorer, type your camera's IP address in the address bar. The
default IP address is 192.168.0.99.
NOTE:
There are two ways to assign an IP address to an IP camera.
1. An IP address can be obtained automatically from a Dynamic Host Configuration Protocol (DHCP)
according to the network parameters.
2. Use a manually specified IP address. See paragraph 6.3.1 for details. Contact your system
administrator to avoid IP address conflict.
NOTE:
To view camera image without showing control panel, type «http://<IP>/index2.htm» in browser's
address bar. <IP> means IP address of your camera
Step 3: enter username
and password in the authorization
window (Pic. 4.1).
The default user name is
« »
admin , the default password is
« »
admin .
IMPORTANT:
You can change user name and password at SETTING – Basic – Security – Account. If you forgot your
user name or password, you can reset your camera to factory settings by holding [RESET] button during
10-15 seconds. Hold [RESET] button during 5-7 seconds to restart the camera.
By default, Windows prevents ActiveX add-ons from running which are required to operate
an IP camera. Therefore, you need to install the ActiveX add-on to operate your camera.
N1250 Operations User Manual
Chapter 4. Managing the IP Camera via Internet Explorer
Pic. 4.1
12