Stapler/Stacker Controller Card Assembly Removal - Lexmark T650 Service Manual

Stapler/stacker controller card assembly removal

1. Remove the left cover. Go to
2. Disconnect all harnesses to the controller card.
3. Remove the three screws (A) securing the stapler/stacker controller card assembly.
4. Remove the stapler/stacker controller card assembly.
Sensor (HCIT tray raised HP) with cable assembly removal
Note: Carefully remove the base machine from the HCIT tray assembly before proceeding.
1. Remove the HCIT cover, left. Go to
page 4-122.
"SFP stapler assembly left cover removal" on page
A
"High capacity input tray (HCIT) cover, left removal" on
4062-XXX
4-174.
4-193
Repair Information
Previous
Next
Go Back