Lexmark T650 Service Manual page 109

Error
code or Error contents
message
28x.43 Right tamper does not
move to home
x = bin
position failure.
number
Applies to:
StapleSmart finisher
28x.44 Eject home position
jam
x = bin
number Applies to:
StapleSmart finisher
28x.45 Eject home position
jam
x = bin
number Applies to:
StapleSmart finisher
28x.46 Paddle home position
jam
x = bin
number Applies to:
StapleSmart finisher
28x.47 Paddle home position
jam
x = bin
number Applies to:
StapleSmart finisher
Description/Action
The sensor (right tamper HP)
does not detect that the tamper
has reached home position.
The sensor (eject HP) does not
detect that the eject
mechanism is operating.
The sensor (eject HP) does not
detect the home position upon
completion of normal media
eject operation.
The sensor (paddle HP) does
not detect that the paddle is
operating.
The sensor (paddle HP) does
not detect the home position
upon completion of normal
paddle operation.
Possible repair actions
1. Check all the connections on
the output option controller
card.
2. Check the tamper drive belt
for damage and replace if
needed.
3. Replace the right tamper
motor assembly.
Go to "SFP stapler assembly
tamper drive motor
assembly removal" on
page 4-181.
4. Replace the sensor (tamper
HP).
Go to "SFP stapler assembly
sensor (tamper HP left and
right) removal" on
page 4-188.
4. Replace the output option if
problem remains.
1. Check all the connections on
the output option controller
card.
2. Replace the output option if
problem remains.
1. Check all the connections on
the output option controller
card.
2. Replace the output option if
problem remains.
1. Check all the connections on
the output option controller
card.
2. Check the sensor (paddle
HP) for damage and replace if
needed.
Go to "SFP stapler assembly
sensor (paddle HP) removal"
on page 4-186.
3. Replace the output option if
problem remains.
1. Check all the connections on
the output option controller
card.
2. Check the sensor (paddle
HP) for damage and replace if
needed.
Go to "SFP stapler assembly
sensor (paddle HP) removal"
on page 4-186.
3. Replace the output option if
problem remains.
Diagnostic information
4062
Previous
Next
Go Back
2-73