Step
5
Check the aligner assembly for proper adjustment.
Go to
"Alignment assembly adjustment" on
page
4-4.
Does the problem remain?
6
Perform a print test.
Does the problem remain?
Media damage
Leading edge
Trailing edge
Step
1
Check printer installation placement.
Check the installation surface for irregularities.
Check for missing printer foot.
Is the setup surface normal?
2
Check the media feed.
Remove the media tray assembly.
Properly load media in the media tray assembly.
Properly install the media tray assembly in the printer.
Re-print the defective image.
Does the error continue?
3
Check the media condition.
Load new, dry, recommended media.
Re-print the defective image.
Does the error continue?
Check
Check
Yes
No
Go to step 6.
Replace the
aligner
assembly.
Go to
"Output
cover
assembly
removal" on
page
4-53.
Contact next
Problem solved.
highest level of
tech support.
Yes
Go to step 2.
Correct the
installation
placement.
Go to step 3.
Problem solved.
Go to step 4.
Problem solved.
Diagnostic information
4062
Previous
Next
Go Back
No
2-167