Feed Tests (Input Tray) - Lexmark T650 Service Manual

Feed Tests (input tray)

This test lets the servicer observe the paper path as media is feeding through the printer. A blank sheet of
paper feeds through the printer as the laser turns off during this test. The only way to observe the paper path is
to open the lower front door that is used to access the envelope or multipurpose feeder. The paper is placed in
the output bin.
To run the Input Tray Feed Tests:
1. Select Feed Tests from INPUT TRAY TESTS.
2. Select the input source from the sources displayed on the Feed Tests menu. All installed sources are
listed.
3. Select either Single or Continuous.
•
Single—feeds one sheet of media from the selected source.
•
Continuous—media continues feeding from the selected source until Stop
Sensor Test (input tray)
This test is used to determine if the input tray sensors are working correctly. To run the Input Tray Sensor Test:
1. Select the Sensor Test from INPUT TRAY TESTS.
2. Select the input source from the sources displayed on the Sensor Test menu. All installed sources are
listed.
3. Select the sensor to test. Various sources have different combinations of sensors. See the table below:
Tray sensor support by source
Source
Tray 1
Tray 2
Tray 4
Tray 5
Multi-Purpose Feeder
Envelope feeder
[sensor selected]=OP displays.
•
Empty—Input tray empty sensor
•
Low—Input tray paper low sensor
•
passThru—Input tray pass thru sensor
4. Once this message displays, the servicer can manually actuate each sensor. The tray empty sensor can
be actuated by hand, however a sheet of paper can be used to cover the pass thru sensor. When the
sensor is closed, Closed displays; when the sensor is open, Open displays.
5. Press Back
OUTPUT BIN TESTS
Feed Tests (output bins)
Empty
(Input tray empty
sensor)
X
X
X
X
X
X
or Stop to exit the test.
Low
(Input tray paper low (Input tray pass thru
sensor)
X
X
X
X
4062-XXX
Previous
Go Back
is pressed.
passThru
sensor)
X
X
X
X
3-15
Diagnostic aids
Next