Sheet Option Drive Shaft With Spring Removal - Lexmark T650 Service Manual

550-sheet option drive shaft with spring removal

1. Remove the 550-sheet frame assembly. Go to
2. Pinch the two hooks (A) on the cap, and detach it from the 550-sheet frame.
3. Pull the drive roll gear (B), the shaft with spring (C), and the bevel out through the opening.
4. Remove the 550-sheet option drive shaft with spring.
Anti-tip latch assembly removal
Note: Carefully remove the base machine from the input option tray assembly before proceeding.
The left and right anti-tip latch assemblies are the same, and only one is in a package. The instructions below
are for removing the left latch, but removing the right latch is similar.
1. Remove the 250-sheet media tray assembly. Go to
"Media size actuator removal" on page
A
A
B
C
A
"250-sheet option tray assembly" on page
4062-XXX
4-160.
4-101.
4-113
Repair Information
Previous
Next
Go Back