Lexmark T650 Service Manual page 42

4062
Error
code or
message
44.01 RFID Error
44.11 RFID Error
44.12 RFID Error
44.13 RFID Error
44.14 RFID Error
44.15 RFID Error
44.16 RFID Error
44.17 RFID Error
44.18 RFID Error
44.19 RFID Error
44.20 RFID Error
44.21 RFID Error
44.22 RFID Error
44.23 RFID Error
44.24 RFID Error
44.25 RFID Error
2-6
Service Manual
Error contents
Bad tag error: a tag has failed
to program, or the "Retry
Count" has been exceeded.
Note: This error is not a data
parsing error, but indicates bad
RFID media. It is posted only if
the "Stop on Error" menu
setting is set to "ON".
Generic parse error
Subcommand appears
truncated
Subcommand appears longer
than expected
Subcommand field value was
invalid
Invalid subcommand format
(invalid magic byte)
Subcommand format valid but
not supported
Illegal chars in subcommand
for specified format
Invalid op code
Valid but unsupported op code
Invalid protocol
Valid but unsupported protocol
Unsupported option supplied
for operation
Invalid ID length
Invalid ID bit pattern
Too many tags on page (too
many means more than one)
Description/Action Possible repair actions
1. Retest using new RFID
media.
2. Check the RFID firmware
card, RFID interface card,
RFID cable, and RFID
option for correct
installation. Go to
"Installing / Removing
the RFID UHF option" on
page 4-149.
3. Replace the RFID UHF
option.
1. These error codes most
likely indicate a problem
with the customer's
datastream, and not the
RFID Option itself. Ensure
there is nothing wrong with
the customer's datastream.
2. Check the RFID firmware
card, RFID interface card,
RFID cable, and RFID
option for correct
installation. Go to
"Installing / Removing
the RFID UHF option" on
page 4-149
3. Replace the RFID UHF
option.
Previous
Next
Go Back