Gap Adjust - Lexmark T650 Service Manual

Touch Back to return to Diagnostics Menu.

Gap Adjust

The setting adjusts the minimum gap between sheets. Increasing this value may reduce curl of some printed
media and eliminate some output bin stacking problems. However, increasing this value also results in slower
overall performance, measured in pages per minute. The range of values is 0 to 255, and the default value is 0.
Touch Back to return to Diagnostics Menu.
Auto Dark Adjust
The settings are Enable and Disable.
REPORTS
Menu Settings Page
This enables you to print the Menu Settings Page. The report prints the Diag Menu to include Registration,
Print Tests, Hardware Tests, Duplex Tests, Input Tray Tests, Output Bin Tests, Device Tests, Printer Setup,
EP Setup, Reports, Event Log, Development Menu, and Scanner Tests.
EVENT LOG
Display Log
The event log provides a history of printer errors. It contains the 12 most recent errors that have occurred on
the printer. The most recent error displays in position 1, and the oldest error displays in position 12 (if 12 errors
have occurred). If an error occurs after the log is full, the oldest error is discarded. Identical errors in
consecutive positions in the log are entered, so there may be repetitions. All 2xx and 9xx error messages are
stored in the event log.
To view the event log:
1. Touch to select Display Log from EVENT LOG.
Up to three error codes display at a time. Touch
2. Touch Back to return to the EVENT LOG menu.
to display additional information, if available.
4062-XXX
Previous
Go Back
3-47
Diagnostic aids
Next