General Setup - Draytek Vigor2130 Series User Manual

4 . 2 . 1 G e n e r a l S e t
4 . 2 . 1 G e n e r a l S e t
This page provides you the general settings for LAN.
Click LAN to open the LAN settings page and choose General Setup.
IP Address
Subnet Mask
For IP Routing Usage
IP Address
Subnet Mask
PPPoE Passthrough
DNS Server Configuration
Start IP Address
u p
u p
Type in private IP address for connecting to a local private
network (Default: 192.168.1.1).
Type in an address code that determines the size of the
network. (Default: 255.255.255.0/ 24)
Click Enable to invoke this function. The default setting is
Disable.
Type in secondary IP address for connecting to a subnet.
(Default: 192.168.2.1/ 24)
An address code that determines the size of the network.
(Default: 255.255.255.0/ 24)
The router offers PPPoE dial-up connection. Besides, you
also can establish the PPPoE connection directly from local
clients to your ISP via the Vigor router. When PPPoA
protocol is selected, the PPPoE package transmitted by PC
will be transformed into PPPoA package and sent to WAN
server. Thus, the PC can access Internet through such
direction.
Enable Server - DHCP stands for Dynamic Host
Configuration Protocol. The router by factory default acts a
DHCP server for your network so it automatically dispatch
related IP settings to any local user configured as a DHCP
client. It is highly recommended that you leave the router
enabled as a DHCP server if you do not have a DHCP server
for your network.
You can configure the router to serve as a DHCP server for
the 2nd subnet. Check the box to enable DHCP server
setting.
Enter a value of the IP address pool for the DHCP server to
start with when issuing IP addresses. If the 2nd IP address of
80
Vigor2130 Series User's Guide