Ports - Draytek Vigor2130 Series User Manual

4 . 2 . 2 P o r t s
4 . 2 . 2 P o r t s
Ports page is used to change the setting for LAN ports. You can set or reset the following
items. All of them are described in detail below.
Port
Link
Speed Current
Speed Configured
Flow Control
Maximum Frame
Excessive Collision Mode
It displays current network interface.
It displays current connection status. Green light means the
WAN connection is successful.
It displays current speed that the router uses.
You can use the drop down list to choose the required speed
for the router. If you have no idea in configuring speed,
simple use the default setting, Auto.
If flow control is enabled by checking Configured box, both
parties can send PAUSE frame to the transmitting device(s)
if the receiving port is too busy to handle. If not, there will
be no flow control in the port. It drops the packet if too much
to handle.
Current Rx: indicates whether pause frames on the port are
obeyed.
Current Tx: indicates whether pause frames on the port are
transmitted.
This module offers 1518~9600 (Bytes) length to make the
long packet for data transmission.
There are two modes for you to choose when excessive
collision happened in half-duplex condition.
82
Vigor2130 Series User's Guide