Yamaha 2010 FX Nytro FX10X Service Manual page 716

Place the throttle cable above
all the other cables.
Parking brake cable
Left handlebar switch
Route the brake hose under the
throttle cable and above the cor-
rugated tube.
Route the corrugated
(engine stop switch lead, throt-
tle switch leads, right grip
warmer lead, and
warmer lead) in front of the cor-
rugated tube (left grip warmer
lead, grip/thumb warmer adjust-
ment switch lead, brake light
switch lead, and headlight beam
switch lead).
Place the wire harness inside
and fasten the corrugated tube
(engine stop switch lead, throt-
tle switch leads, right grip
warmer lead, and
warmer lead) at the headlight
stay with the plastic band.
To the wire harness
Fasten the headlight unit lead
and speedometer unit sub-lead
to the headlight stay with the
plastic band.
To the headlight (left)
To the throttle body
To the headlight (right)
To the coolant reservoir
To the parking brake
To the brake caliper
Pass the corrugated tubes and
parking brake cable through the
guide.
Right handlebar switch
Middle adjuster 6 Nm (0.6
m•kgf, 4.3 ft•lbf)
Throttle cable
Fasten the corrugated tube (left
grip warmer lead, grip/thumb
warmer adjustment switch lead,
brake light switch lead, and
headlight beam switch lead),
corrugated tube (engine stop
switch lead, throttle
leads, right grip warmer lead,
and thumb warmer lead), and
brake hose with the plastic
band. (FX10M53Z/
FX10M53SZ/FX10M62SZ)
Brake hose
tube
thumb
thumb
switch
166
CABLE ROUTING
SPEC