Steering; Installation - Yamaha 2010 FX Nytro FX10X Service Manual

STEERING

STEERING

INSTALLATION

1. Install:
• Tie rod
• Locknuts
• Joints
Tie rod part
number
8HK-23831-00
(FX10Y/
FX10RTRY/
FX10RTRSY/
FX10XTY)
8HA-23831-00
(FX10MTRY)
FX10Y/FX10RTRY/FX10RTRSY/FX10XTY
FX10MTRY
2. Install:
• Tie rods
TIP
Make sure that the indentation
rod faces out.
NOTICE
• After tightening the inside and outside ball
joint locknut , make sure the tie rod
can be rotated freely through the ball joint
travel. If not, loosen the locknut
reposition the ball joint so that the tie rod
can be rotated freely. Tighten the lock-
nut to specification.
• Always use new cotter pins.
Tie rod end locknut:
25 Nm (2.5 m•kg, 18 ft•lb)
LOCTITE
Tie rod and pivot arm nut:
35 Nm (3.5 m•kg, 25 ft•lb)
Tie rod and steering knuckle nut:
28 Nm (2.8 m•kg, 20 ft•lb)
34
CHAS
Set Tie rod
length length
527.0 mm 458.5 mm
(20.75 in) (18.05 in)
518.0 mm 449.5 mm
(20.39 in) (17.70 in)
on the tie
and
®