Yamaha 2010 FX Nytro FX10X Service Manual page 591

STEERING
5. Adjust:
• Skis
Adjustment steps:
• Temporarily install the handlebar.
• Hold the handlebar straight and check that
the skis are at right angles to the handlebar.
• Install the steering linkage alignment plate
(steering link holder)
TIP
To install the steering linkage alignment plate,
turn the handlebar completely to the right,
position the plate behind the steering column
, and then fit the steering column into the
cutout in the plate and fit the nut
hole in the plate. Then, while turning the han-
dlebar to face it straight ahead, fit the bolt
into the hole in the plate.
Steering linkage alignment plate:
YS-01531
Steering link holder:
90890-01531
• Loosen the steering shaft locknuts
• Adjust the steering shaft
that the pivot arm point right under.
Turning the steering
shaft in direction
Turning the steering
shaft in direction
• Tighten the steering shaft locknuts
Steering shaft locknut:
25 Nm (2.5 m•kgf, 18 ft•lbf)
LOCTITE
• Adjust each angle of right and left skis by
turning the tie rod respectively.
• Measure the ski toe-out.
Refer to "STEERING SYSTEM" in CHAP-
TER 2.
41
CHAS
.
into the
.
by turning so
Turning the ski
in direction
Turning the ski
in direction
.
®