Yamaha 2010 FX Nytro FX10X Service Manual page 710

SPEC
CABLE ROUTING
To the main switch
To the brake master cylinder
To the parking brake lever
To the brake light switch
Brake light switch coupler.
Route the brake light switch
lead through the rubber coupler.
(FX10M53Z/FX10M53SZ/
FX10M62SZ)
To the left handlebar switch
Route the plastic band through
the rubber cover hole, and then
fasten the cover together with
the headlight unit harness to the
headlight stay. Make sure that
the band is not fastened over
the projections on top of the
cover.
Make sure the clamp is not over
the rubber cover flange. The
flange of the rubber cover
should not be loose.
Slide the rubber coupler over
the grip/thumb warmer adjust-
ment switch coupler, left grip
warmer coupler, brake light
switch coupler, and headlight
beam switch coupler.
To the air filter case
Fasten the wire harness to the
headlight stay with the plastic
band.
Flange bolt 4 Nm (0.4 m•kgf, 2.9
ft•lbf)
Main fuse
Starter relay
Blind rivet
Fasten the starter motor lead to
the oil tank inlet hose with the
plastic band, making sure not to
pinch the hose.
Fasten the AC generator lead to
the front frame with the plastic
band, making sure to route it to
the inside of the frame.
To the rectifier/regulator
To the engine
Fasten the positive battery lead
to the oil tank breather pipe with
the plastic band.
Face the clamp to front of the
snowmobile and route the park-
ing brake cable.
To the AC magneto
160