Yamaha 2010 FX Nytro FX10X Service Manual page 512

Parts to be tightened
Rear pivot arm bracket and sliding frame bolt
Rear pivot arm and rear pivot arm bracket bolt
Rear pivot arm and control rod stopper nut
Control rod adjusting locknut
Control rod shaft and sliding frame
Rear axle nut
Set bolt (front axle)
Speed sensor
Bearing holder (front axle)
Bearing housing bolt
Bearing housing bolt
Gear unit (speed sensor) bolt
TIP
Tightening steps:
1. Tighten the bolt to a torque at 120 Nm (12.0 m•kg, 85 ft•lb).
2. Loosen the bolt completely.
3. Retighten the bolt to a torque of 60 Nm (6.0 m•kg, 43 ft•lb).
TIGHTENING TORQUE
Tightening torque
Nm m•kg ft•lb
72 7.2 52
72 7.2 52
60 6.0 43
25 2.5 18
72 7.2 52
75 7.5 54
9 0.9 6.5
24 2.4 17
24 2.4 17
30 3.0 22
24 2.4 17
40 4.0 29
96
SPEC
Remarks
(FX10Y/FX10RTRY/
FX10RTRSY)
®
Apply LOCTITE
(FX10Y/FX10RTRY/
FX10RTRSY)
®
Apply LOCTITE
(FX10XTY/FX10MTRY)
(FX10XTY/FX10MTRY)
(FX10XTY/FX10MTRY)
®
Apply LOCTITE
Left side
Right side