Yamaha 2010 FX Nytro FX10X Service Manual page 659

CRANKCASE
6. Tighten:
• Crankcase bolts
TIP
Tighten the bolts in the order of the embossed
numbers on the crankcase.
Crankcase bolt
24 Nm (2.4 m•kgf, 17 ft•lbf)
Crankcase bolt
12 Nm (1.2 m•kgf, 8.7 ft•lbf)
7. Install:
• Primary sheave drive shaft assembly bolts
Primary sheave drive shaft
assembly bolt:
12 Nm (1.2 m•kgf, 8.7 ft•lbf)
8. Install:
• Crankshaft position sensor
• Crankshaft position sensor bolt
TIP
Put the crankshaft position sensor lead
the AC magneto side and then install the plate
.
Crankshaft position sensor bolt:
10 Nm (1.0 m•kgf, 7.2 ft•lbf)
LOCTITE
9. Install:
• Engine mounting bracket
• Engine mounting bracket
(with the ground lead stopper
• Engine mounting bracket bolts
TIP
When installing the engine mounting brackets,
make sure that the number on each side of the
upper crankcase is aligned with the identical
number on the brackets.
Engine mounting bracket bolt:
25 Nm (2.5 m•kgf, 18 ft•lbf)
109
ENG
~
~ :
~ :
®
)
to