Yamaha 2010 FX Nytro FX10X Service Manual page 436

Hide thumbs Also See for 2010 FX Nytro FX10X:

Table of Contents

FRONT SUSPENSION

Do not overtighten the connector onto the

air valve as this will damage the connector

If the shock absorber has no air pressure, the

gauge reading will be zero.

• To increase the air pressure, operate the

pump a few times. The pressure should

increase slowly. If the pressure increases

rapidly, check to make sure that the pump is

properly connected and tightened onto the

air valve. To decrease the air pressure,

push the bleed valve button

To allow pressure to escape from the pump

and the shock absorber, push the button half-

way down and hold it. To allow only a small

amount of pressure to escape, push the button

all the way down and quickly release it.

• Remove the hose connector from the air

When removing the connector, the sound of air

escaping may be heard, but this is from the

pump hose, not the shock absorber.

Air pressure range:

345 kPa (3.4 kg/cm², 50 psi) to

1,034 kPa (10.3 kg/cm², 150 psi)

Recommended air pressure:

517 kPa (5.3 kg/cm², 75 psi)

621 kPa (6.2 kg/cm², 90 psi)