Yamaha 2010 FX Nytro FX10X Service Manual page 523

To the main switch
To the brake master cylinder
To the parking brake lever
To the brake light
(FX10MTRY)
Brake light switch coupler.
Route the brake light switch
lead through the rubber coupler.
(FX10MTRY)
To the left handlebar switch
Route the plastic band through
the rubber cover hole, and then
fasten the cover together with
the headlight unit harness to the
headlight stay. Make sure that
the band is not fastened over
the projections on top of the
cover.
Slide the rubber coupler over
the grip/thumb warmer adjust-
ment switch coupler, left grip
warmer coupler, brake light
switch coupler (Except
FX10MTRY), and headlight
beam switch coupler.
To the air filter case
Fasten the wire harness to the
headlight stay with the plastic
band.
Flange bolt 3 Nm (0.3 m•kg, 2.2
ft•lb)
Main fuse
Starter relay
Fasten the starter motor lead to
the oil tank inlet hose with the
plastic band, making sure not to
pinch the hose.
Fasten the AC generator lead to
the front frame with the plastic
band, making sure to route it to
the inside of the frame.
To the rectifier/regulator
To the engine
Fasten the positive battery lead
to the oil tank breather pipe with
the plastic band.
To the AC magneto
Pass the negative battery lead
between the parking
cable and the frame.
To the starter motor assembly
Flange bolt 23 Nm (2.3 m•kg,
17 ft•lb)
Guide
Make sure that the catch of the
holder is facing downward.
switch
for
brake
107
CABLE ROUTING
SPEC