Yamaha 2010 FX Nytro FX10X Service Manual page 525

SPEC
CABLE ROUTING
Route the DC back buzzer lead
above the guide and route the
wire harness under the guide.
Fuse box bracket
Fuse box
Route the tail/brake light lead
through the rib of the right fuel
tank cover and under the fuel
tank seam.
Right fuel tank cover
Tail/brake light coupler
Pass the wire harness and DC
back buzzer lead through the
guide, making sure that the
guide is positioned to the front
of the bolt.
Negative battery lead
Fasten the tail/brake light lead
and fuel sender lead to the
frame rear cross member with
the plastic band.
Battery
Negative battery lead coupler
Fuel sender coupler
DC back buzzer coupler
Install the battery bracket by
pressing it down.
Fasten the wire harness to the
frame rear cross member with
the plastic band, face the end of
the plastic band upward.
Fasten the brake hose with the
holder.
Fit the wire harness to the
clamp of the frame rear cross
member and fasten it with the
plastic band.
Main switch coupler
Parking brake cable
Fasten the parking brake cable
with the holder, making sure to
bend the holder so that its end
contacts the side of the bolt
head as shown in the illustra-
tion.
DC back buzzer lead
Wire harness
Fuel tank installation, Wire har-
ness routing direction
Location of the wire harness
before installing the fuel tank
Fuel tank installation
Location of the wire harness
after installing the fuel tank
Plastic band
Frame rear cross member
109