Yamaha 2010 FX Nytro FX10X Service Manual page 517

SPEC
CABLE ROUTING
Fasten the tail/brake light lead
(wire harness side) to the frame
rear cross member with the
plastic band.
Tail/brake light coupler
Fasten the tail/brake light lead
with the holders, making sure to
push the lead against the fuel
tank.
Fuel hose connector holder
Fuel hose
Fasten the fuel hose and fuel
pump lead with the plastic band.
Align the plastic band with the
positioning tape on the fuel
pump lead and install it with its
buckle facing toward the fuel
tank.
Be sure to install the fuel tank
breather joint hose with its long
end facing to the right
Face the ends of the hose
clamp rearward.
Place the white taped part of
the wire harness and clamp left
of the rivet hole.
Speed sensor coupler
Radiator fan motor coupler
Fuel injection system sub-wire
harness coupler
Fasten the coolant reservoir
hose with the holder.
Fasten the wire harness, at the
portion just before the leads
split, to the front frame with the
plastic band.
To the coolant reservoir
Flange bolt 6.5 Nm (0.65 m•kg,
4.8 ft•lb)
Band
101