Yamaha 2010 FX Nytro FX10X Service Manual page 452

STEERING
5. Adjust:
• Skis
Adjustment steps:
• Temporarily install the handlebar.
• Hold the handlebar straight and check that
the skis are at right angles to the handlebar.
• Install the steering linkage alignment plate
.
TIP
To install the steering linkage alignment plate,
turn the handlebar completely to the right,
position the plate behind the steering column
, and then fit the steering column into the
cutout in the plate and fit the nut
hole in the plate. Then, while turning the han-
dlebar to face it straight ahead, fit the bolt
into the hole in the plate.
Steering linkage alignment plate:
90890-01531, YS-01531
• Loosen the steering shaft locknuts
• Adjust the steering shaft
that the pivot arm point right under.
Turning the steering
shaft in direction
Turning the steering
shaft in direction
• Tighten the steering shaft locknuts
Steering shaft locknut:
25 Nm (2.5 m•kg, 18 ft•lb)
LOCTITE
• Adjust each angle of right and left skis by
turning the tie rod respectively.
• Measure the ski toe-out.
Refer to "STEERING SYSTEM" in CHAP-
TER 2.
36
CHAS
into the
.
by turning so
Turning the ski
in direction
Turning the ski
in direction
.
®