Installing Modules - D-Link DES-6300 User Manual

Modular L3 Ethernet Switch User's Guide

Installing Modules

The DES-6300 supports up to 6 modules that can be installed into the module bays. Networking
modules are warm-swappable, meaning they can be added and removed while power to the
switch is ON. After warm-swapping a networking module, the switch will automatically be
rebooted. Make sure to use the Save Changes command to save the current configuration to NV-
RAM before warm-swapping modules. The CPU module, however, is NOT hot-swappable.
Removing or inserting the CPU module while the power is on may cause irreparable damage to
the module and/or to the Switch itself. Further, make sure you have unplugged the power cord
from the removable power supply module before inserting or removing it from the Switch.
CAUTION: Due to the high energy present in this system, extreme caution
should be exercised whenever adding or removing system components. No
element of this system may be installed or removed except by an authorized
technician.
Modules can be installed into any free slot, except the CPU module. The CPU module must be
installed in the uppermost (top) slot. To install a module, simply remove a blank slot cover and
slide the module along the guide rails until it snaps firmly in place.
Figure 2- 3. Removing a Blank Slot Cover
9