Table of Contents
Advertisement
Installing Network Modules
This section describes how to install WAN & Voice Network Modules in D-Link DI-3660 routers.
Before performing any of the following procedures, ensure that power to the Router is OFF.
Caution:
Do not insert the module into any slot of the router when power is ON or network cables are connected.
To install a Network Module in D-Link DI-3660 router, follow these steps:
1. Power OFF the router.
2. To avoid ESD voltage damaging the equipment, channel the router body to ground.
3. Remove all network interface cables, including telephone cables, from the rear panel.
4. Use a flat-blade screwdriver to remove the blank filler panel from the slot where you plan to install the card.
Save the filler panel for possible future use.
5. Align the module with the guides in the chassis and slide it gently into the slot as shown in the following figure.
6. Push the module into place until the edge connector is securely seated in the connector on the motherboard. Ensure
that each of the module's captive screws lines up with its corresponding hole in the chassis.
7. Secure the captive mounting screws into the holes of the chassis using a flat-blade screwdriver.
8. After completion of the hardware installation, begin the software configuration (refer Software Installation Guide).
Network Module Combination Matrix
For choosing the correct Network Module for WAN & Voice connectivity please refer the Network Module Matrix
below.
No.
Description
1
One-port 10/100Base-TX
2
Two-port 10/100Base-TX
3
One-port 10/100Base-FX (Multi-Mode)
4
One-port 10/100Base-FX (Single-Mode)
5
One-port
Sync/Async (up to 2Mbps)
6
Two-port serial, async, and sync (up to
2Mbps) + one-port ISDN BRI
__________________________________________________________________________________________________________________
Ethernet
+
two-port
17
Part Code
DRM-1FE-TX
DRM-2FE-TX
DRM-1FE-FX
DRM-1FE-FS
serial,
DRM-1E2T
DRM-2T1B
DI-3660 Router
SLOT1~6
Yes
Yes
Yes
Yes
Yes
Yes
Advertisement
Table of Contents
