Rip Interface Parameters - D-Link DES-6300 User Manual

Modular L3 Ethernet Switch User's Guide
The RIP Parameters window displays the following:
Administrative Status – The RIP administrative status in the router. Enabled
means the RIP process is active on at least one interface. Disabled means the
process is not active on any interfaces.
Leak OSPF Routes – Controls redistribution of routes from OSPF to RIP. When
this parameter is enabled, all routes learned via OSPF are advertised into RIP.
Leak Static Routes – Controls redistribution of routes from static routes to RIP.
When this parameter is enabled, all static routes learned via static are advertised
into RIP.
To edit RIP Parameter fields:
1. Display the RIP Parameters window.
2. Edit fields to Enable or Disable.
3. Click . When the Status field displays "Finished!", the fields are confirmed as
modified.

RIP Interface Parameters

To display the RIP Interface Table:
Select Router > IP > RIP > Interface Parameters. The RIP Interface Table opens:
Figure 6- 92. RIP Parameters window
132