Installing Modules - D-Link DES-6300 User Manual

Installing Modules

The DES-6300 supports up to 6 modules which can be installed into the module bays.
Networking modules are warm-swappable, meaning they can be added and removed
while power to the switch is ON. After warm-swapping a networking module, the switch
will automatically be rebooted. Make sure to use the Save Changes command to save
the current configuration to NV-RAM before warm-swapping modules. The CPU module,
however, is NOT hot-swappable. Removing or inserting the CPU module while the power
is on may cause irreparable damage to the module and/or to the Switch itself. Further,
make sure you have unplugged the power cord from the removable power supply
module before inserting or removing it from the Switch.
CAUTION: Due to the high energy present in this
system, extreme caution should be exercised whenever
adding or removing system components. No element of
this system may be installed or removed except by an
authorized technician.
Figure 2-3. Removing a Blank Slot Cover